Burst Pipe Etobicoke
Burst pipe Etobicoke owners find in a winter cold snap often hides in an exterior wall or a garage, and the damage can run for hours before it shows.
Fully licensed and insured
Open 24 hours, 7 days
First steps
Close the main shut-off, drain the line by opening a low tap, and keep clear of wet electrical equipment. Then call us.
We extract, trace the water with thermal imaging and dry the structure. Condo owners should also notify the property manager so the building can shut down the riser if needed.
Cold snaps and old lines
Most burst pipes here happen when a hard freeze catches an unheated section: a garage ceiling, a crawl space, a cold cellar or a plumbing run in an exterior wall. When the thaw comes, the split opens up and water runs for as long as nobody is home. That is why a burst can empty into a house for hours before you notice.
If you are away, ask a neighbour to check the house during very cold weather. If you come home to water, close the main valve, stay clear of electrical equipment and call us.
Etobicoke buildings and burst pipes
Older homes in Long Branch and Mimico have plumbing of several generations, sometimes in one wall. Mid-century homes in The Kingsway have long runs through finished basements. Towers have risers, and a failed riser fitting can flood a unit within minutes. Our drying plan changes with each.
Typical sources
- Exterior wall plumbing
- Water heaters
- Washing machine hoses
- Condo risers
The first ten minutes
Close the main shut-off, open the lowest tap to drain the line, and keep clear of any light fitting with water dripping from it. If water has reached an outlet or the panel, do not touch it, and call us from outside the room. Photograph the failed section before a plumber changes it, and lift rugs, electronics and small furniture off wet floors. Opening interior doors helps air move while the crew is on its way.
A plumber repairs the pipe. We dry the building. Booking both on the same day keeps the loss small.
Tracing where the water went
A burst on one floor rarely stays on that floor. Water runs along joists, drops through light fixtures and soaks into wall cavities. We trace its path with a thermal camera and moisture meter, starting at the failed pipe and working outward through ceilings and walls. We then open small, measured holes where readings show water and place air movers and dehumidifiers to dry the cavity from inside.
Because we record readings every day, you can see when each area reaches normal levels. That record is also what your adjuster will want to see.
What to photograph for your insurer
- The failed pipe, fitting or hose and the water shut-off
- Every affected ceiling, wall and floor, wide and close
- Wet furniture and electronics with model labels in view
- Items you move or discard, before they leave the room
- The plumber's invoice and any notes about the cause
Request a quote
Tell us what you need and we will get back to you. In a hurry? Calling is fastest.